Switching From Offline To Online Mode - Salus FC600 Full User Manual

4.11. Switching from offline to online mode

If you want to add the FC to the UGE600 after you set it up, you need to use the 55 code, and than you select
UG YES, and then you confirm PAIR to start joining the UG. On the App you should see all the settings which
have been already done in the past, when you configured the FC600 without the UG. Please see the detailed
procedure as shown. Make sure your UG is connected to the system and you have the App installed.
To begin the pairing process the gateway should be plugged into the power source and connected to the
Internet. Also, make sure that the UG is added to your Salus Smart Home App. For the installation of the Universal
Gateway, please refer to the UG600/UGE600 manual on salus-manuals.com
1
Press the buttons for 3
seconds.
4
M
Press OK
59 Fan Coil FC600 Instructions Manual
Make sure that your Universal Gateway is added to the App. The
led of the Gateway should be steady blue. Once you have that
installed, go to your Fan Coil and begin paring it with the UG and
adding it to the App.
2
3 sec
M
3 sec
3 sec
The digits on the screen will
flash. Using
5
M
.
M
or ,
enter pass 55.
M
antenna sign
will appear in
M
the corner of the
M
At this point you should
go to the App in order to
configure your Fan Coil.
3
M
Press OK
6
The
screen.
Now go to the App. Tap
menu icon .
M
.