• EC Marking directive 93/68/EEC SAFETY INFORMATION These instructions are applicable to the Salus Controls model stated on the front cover of this manual only, and must not be used with any other make or model. These instructions are intended to apply in the United Kingdom only, and should be followed along with any other statutory obligations.
Page 3
The FT100 from Salus Controls is a stylish mains voltage thermostat that can switch a pump, zone valve or boiler to provide localised protection from freezing, regardless of the heating controller settings.
The ideal position to locate the FT100 frost thermostat is about 1.5m above floor level, in a location where the thermostat is accessible, reasonably lit and free from extremes of temperature and draughts.
OPERATION The FT100 is adjusted very easily by turning the rotary dial on the front of the thermostat to the required frost protection temperature. To adjust the set temperature, unclip the protective cover and turn the rotary dial to the left to set a lower temperature, or to the right to set a higher temperature.
Salus FT100 Manual 001:89 29/11/10 22:57 Page 6 PRODUCT SPECIFICATION Model: FT100 Type: Surface mounted electronic frost thermostat designed for 230V AC heating applications. Switching Switching Voltage: 230V AC / 50Hz Switching Current: 8A resistive, 3A inductive Contact Type: Single Pole Single Throw (SPST)
Page 7
Page 7 FT100 Warranty Salus Controls warrants that this product will be free from any defect in materials or workmanship, and shall perform in accordance with its specification, for a period of two years from the date of purchase. Salus Controls sole liability for breach of this warranty will be (at its option) to repair or replace the defective product.