Change the Setpoint temperature
The thermostat displays
measured room temperature.
After 2 seconds, the new temperature
setpoint will be overwritten.
Frost Protection
Press
ON/OFF frost protection.
The Frostpoint temperature can be reviewed by pressing the
in Installer Mode.
Sleep Mode
When Sleep Mode is active all the thermostat functions will be paused.
To enter sleep mode, press and hold
and
button to turn
3 sec
3 sec
for 3 seconds.
Press
to set the temperature.
The thermostat will display the measured temperature
again. The heating mode icon will appear if the temperature
setpoint is higher than the measured temperature.
When the snowflake icon is displayed
then it means that the frost protection
mode is active.
button once, but can only be changed
To exit sleep mode,
press twice any button.
or
,