Switching From Offline To Online Mode - Salus FC600 Instruction Manual

4.9 Switching from offline to online mode

If you want to add the FC to the UGE600 after you set it up, you need to use the 55 code, and than you select
UG YES, and then you confirm PAIR to start joining the UG. On the App you should see all the settings which
have been already done in the past, when you configured the FC600 without the UG. Please see the detailed
procedure as shown. Make sure your UG is connected to the system and you have the App installed.
To begin the pairing process the gateway should be plugged into the power source and connected to the
Internet. Also, make sure that the UG is added to your Salus Smart Home App. For the installation of the Universal
Gateway, please refer to the UG600/UGE600 manual on salus-manuals.com
Press the buttons for 3 seconds.
Press OK.
59 Fan Coil FC600 Instruction Manual
Make sure that your Universal Gateway is added to the
App. The led of the Gateway should be steady blue. Once
you have that installed, go to your Fan Coil and begin
paring it with the UG and adding it to the App.
3sec
3sec
M
3sec
The digits on the screen will flash. Using the up/
M
Short press button to confirm pairing. At this
point you should go to the App in order to
M
down keys enter pass 55.
The
antenna sign
will appear in
the corner of the
screen
M
configure your Fan Coil.
M
Press OK.
Now go to the App. Tap menu icon