Advertisement
Main
Sub
code
code
Signal send mode
66
04
Used to send signals to the line and the machine speaker by setting the signal number. (Signal send is
continued until interruption is instructed by pressing RETURN key.) The signal send level is selected from
0db and the soft SW values. Since the level setting is not required for 1:NO SIGNAL and 31:PSEUDO RNG
- 33:R.B.TONE NONE, the selection menu does not appear. The signal send level is returned to the soft SW
set value before execution of the mode when completing the mode.
Confidential pass code print
06
Used to print the confidential ID table (confidential box number, confidential box name, confidential pass
code).
Image memory content print
07
Used to print all the image data (confidential receive contents, remote send images, and images which are
not sent yet) in the image memory of the FAX section. The printed images are remained in the memory after
printing.
Sim66-4 SIGNAL OUT
SIGNAL SELECT
(1 - 35)
1sec later
Sim66-4 SIGNAL OUT
1:NO SIGNAL
2:33600bps(V34)
3:31200bps(V34)
(1 - 35)
XX
After selection with numeric keys
The window is switched with the up and down keys.
[OK] key
Input and switching the window are irrelevant.
Not highlighted with an input of a value.
Sim66-4 SIGNAL OUT
The window is not switched, either.
33600bps(V34)
1:MAX
When "1: NO SIGNAL" or "31: PSEUDO RNG" - "33: R.B. TONE NONE"
2:SOFT SW.
is selected, "0dB" and "SOFT SW" are not selected.
(1 - 2)
X
When one of these is selected, the second line is the signal name,
the third and fourth lines are empty, and the fifth line is EXEC display.
[OK] key
Sim66-4 SIGNAL OUT
[OK] key
33600bps(V34)
0dB
After pressing
EXEC
[OK] key
Sim66-6
PASS CODE
Sim66-6
[OK] key
PRINT CONF.
EXEC
In case of an error
Sim66-7 PRINT MEMORY
PRINT IMAGE MEMORY
EXEC
[OK] key
Sim66-7 PRINT MEMORY
NO DATA
[CA] key
[INTERRUPT] key : Sub code input
[OK] key
[START] key
3sec later
[C] key
[BACK] key
MX-M182 SIMULATIONS 7-53
Contents
[CA] key
: Simulation cancel
[INTERRUPT] key : Sub code input window
[C] key
: Input clear
key
: Page select
Numeric keys
: Number input and item selection
[OK] key
: Input value settlement and execution
[START] key
: Input value settlement
[BACK] key
: Signal send stop
Sim66-4 SIGNAL OUT
34:DP MAKE
35:DP BREAK
(1 - 35)
XX
Sim66-4 SIGNAL OUT
[BACK] key
33600bps(V34)
PRESS BACK TO STOP
EXEC
PASS CODE
Sim66-6
3sec later
PRINT STORED
Sim66-6
PASS CODE
NO DATA
[OK] key
Sim66-7 PRINT MEMORY
PRINT STORED
[OK] key
(When there is no image memory)
Sim66-7 PRINT MEMORY
CAN NOT PRINT
: Simulation cancel
window
: Settlement
: Settlement
: Disable
: Disable
SIM66-4 initial window
PASS CODE
PRINT CONF.
EXEC
1sec later
3sec later
Remark
Advertisement
