Advertisement
Main
Sub
code
code
61
02
Laser power correction ON/OFF (Invalidity)
Enable/Disable of the LSU laser power correction during the operation is set.
When [START] key is pressed, the entered set value is saved and the machine enters the sub code input
standby mode.
Sim61-2 LASER PWR
1:LASER POWER
[ 0 - 1]
Note: Changing the setting does not affect the operation.
03
HSYNC output check
When this simulation is executed, the polygon motor is rotated for 30sec together with the LEND signal.
"EXEC" (indicating execution) and "HSYNC" (HSYNC sensor detecting status) are displayed.
Every time when the HSYNC signal is detected, "HSYNC" display is highlighted for 100ms.
（Initial window）
Sim61-3 LSU CHECK
PRESS OK KEY EXEC
63
01
Shading check
Used to display the detection level when the lamp of the white plate for shading correction is lighted.
When the simulation code is entered, the initial window is displayed to urge execution. Press [OK] key or
[START] key to start the simulation. The contents of the operations are as follows:
1. The mirror base unit is shifted to the white plate for shading correction.
2. The copy lamp is lighted.
3. "0" is displayed until the copy lamp light quantity is stabilized.
4. When the light quantity is stabilized, the level of 1 pixel on the CCD center which is not corrected is
displayed in hexadecimal.
*
The white level is displayed for about 10sec. The data update cycle is about 1sec.
5. After passing 10sec, the machine returns to the sub code input window.
Sim63-1 SHADING
PRESS OK KEY EXEC
64
01
Self print
Used to perform printing of one page disregarding the optical system status. Also when the print command
is issued from the host, printing is performed.
When this simulation is executed, warm-up is performed and the ready lamp is lighted. (Since, however, the
optical system is invalid, initializing is not performed.)
There are following twenty-one self-printable patterns. Use numeric keys to select a pattern.
The selected pattern is displayed on 7-segment LED.
Code
number
0
1
2
3
4
5
6
7
8
9
10
11
M by N (Main scan)
12
Code number :
0
: Correction Enable
1
1
: Correction Disable
1
[OK] key or [START] key
[OK] key or [START] key
Print pattern
Image output
Grid pattern
(1) 1/236
(*1)
(2) 1/128
(3) 1/255
(4) 2/254
Dot print
(1) 1/1
(2) 2/2
(3) 1/255
Equal-pitch pattern
(1) 1/1
M by N (Sub scan)
(2) 1/2
(3) 2/2
Equal-pitch pattern
(1) 1/1
(2) 1/2
(3) 2/2
MX-M182 SIMULATIONS 7-50
Contents
Mode
(Execution window)
Sim61-3 LSU CHECK
HSYNC
EXEC
Sim63-1 SHADING
061
Code
Print pattern
number
13
Black background
area (A4/A4R)
14
(Paper F-R edge)
15
16
Black background
area (whole surface)
17
White background
area (whole surface)
18
HT (whole surface)
19
Black rectangle
20
Black lead edge
21
Cross pattern
Remark
Default:
0
Image output
(1) 1%
(2) 6%
(3) 35%
No pattern
No pattern
No pattern
No pattern
No pattern
No pattern
Advertisement
