Advertisement
4. Contents of simulations
Main
Sub
code
code
01
01
Mirror scanning operation
Used to check the operations of the scanner unit and its control circuit.
Enter the number of times and the magnification ratio, and press [OK] key to operate the scanner unit. The
speed is variable according to the specified magnification ratio. The number of scanning can be specified by
entering a value to the right lower section of the LCD.
•Setting range of magnification ratio: 25%-400%
•Setting range of the number of scanning: 0-999 (When 0 is set, it means unlimited. )
(Scan number input window)
Sim1-1 SCAN CHECK
115%
100%
86%
ZOOM
(Execution
window)
Sim1-1 SCAN CHECK
115%
100%
86%
ZOOM
Used to display the status (ON/OFF) of the mirror HP sensor on the LCD during scanning. (Highlighted at
ON)
"EXEC" is displayed to indicate execution is in process. The scan counter is displayed above "EXEC." This
counter is counted up even in simulation.
The copy lamp is lighted during scanning.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Returns to the sub code input window.
[C] key: Input value clear
Numeric keys: Input of the number of scanning
02
Mirror home positions sensor (MHPS) status display
Used to monitor the mirror home position sensor and display the ON/OF status of the sensor on the LCD.
Sim1-2 SENSOR CHECK
MHPS
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Returns to the sub code input window.
Set the scan magnification ration.
This magnification ratio accords with the scan speed
MHPS
in actual copying. The setting range is 25% - 400%.
123
Specify the scan number to be performed.
100%
5
The setting range is 0 - 999. When 0 is set,
the number is unlimited.
[OK] key or [START] Key
MHPS sensor status
MHPS
Scan counter
123
100%
EXEC
Highlighted during execution
MHPS(MIRROR HOME POSITION SENSOR)
ON
:Highlight display
OFF
:Normal display
MX-M182 SIMULATIONS 7-3
Contents
Remark
Advertisement
