Advertisement
2. Maintenance display system
Toner
Life,
Remaining
quantity check *1
Remaining
quantity
Message and icon
on the LCD
Machine
Developer
Life
Message and icon
on the LCD
Machine
Maintenance Message and icon
on the LCD
Machine
*1:Installation of a new toner cartridge allows to display the remaining quantity.
3. Note for replacement of consumable parts
A. Toner cartridge
When a waste toner cartridge is removed from the machine, it must be
put in a polyethylene bag to avoid scattering of toner.
B. DV cartridge
Do not shake or put up the developer cartridge. Otherwise developer
may scatter.
a. Press and hold the density adjustment LIGHT key for more than 5 sec, and the machine will enter the user
program mode.
b. Press and hold the "%" key for more than 5 sec, and the remaining quantity will be displayed on the copy quantity
display in one of the following levels: (Remaining quantity display levels: 100%, 75%, 50%, 25%, 10%, LO)
c. Press the density adjustment LIGHT key to cancel.
NEAR EMPTY
EMPTY
About 10%
ON
Flash
Operation allowed Stop
50K
ON at 50K of the
developer count
Selection is available between Not Stop and Stop by Service Simulation (SIM 26-37) Setup.
(If Stop is selected, the LED will flash and stop at 50K.)
* Default: Not Stop
* Clear: SIM 42-1
Selection is available among 50K, 25K, 10K, 7.5K, 5K, and free (no lighting) with SIM 21-1.
* Default: 50K
* Clear: SIM 20-1
Not stop
MX-M182 MAINTENANCE 9-2
16K
C. DV seal attachment procedure
(When viewed from the front)
Side molt F
Clearance with the
molt edge.
Must not be covered.
0
DV Side
sheet F
Molt edge
reference
0
0.5
0.3
Attach with the
projection (rib)
reference
(When viewed from the front)
Side molt R
Clearance with the
molt edge.
Must not be covered.
DV Side
0
sheet R
Molt edge
reference
0
0.5
0.3
Attach with the
line (mark-off line)
reference.
Advertisement
