Advertisement
Main
Sub
code
code
26
06
Destination setting
Used to set the destination of the main unit.
When this simulation is executed, the code number of currently set destination is displayed.
Sim26-6 DESTINATION
1:DESTINATION
0=JAPAN
[ 0-6]
[0] - [6] (Default: Depends on the model.)
Enter a value with numeric keys, and press [OK] key or [START] key, and the current adjustment value is
saved in the EEPROM.
[CA] key: Exits the simulation mode. (When setting is changed, the machine exits the simulation mode and
performs the hard reset.)
[INTERRUPT] key: Shifts to the sub code input window. (When setting is changed, it is invalid.)
[START] key: Setting contents are saved in the EEPROM and the machine shifts to the code input window.
*
When this setting is changed, the following adjustment values and the set values are automatically
changed according to the set destination.
O SIM46-19 (
O SIM46-30 (AE limit setting)
O Paper size (A4 for AB series, LT for inch series)
O Maintenance cycle (Returns to the default (Japan/Ex Japan). )
O Mini maintenance cycle (Only when setting is changed to Japan.)
07
Machine condition check
When this simulation is executed, the copy speed of the machine is displayed.
Sim26-7 CPM CHECK
18CPM
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
08
Manual transfer shaking countermeasures setting
Used to set the countermeasures against manual transfer shaking.
When this simulation is executed, the current set value is displayed. Enter a set value with numeric keys and
press [OK] key or [START] key. The set value is saved in the EEPROM.
Sim26-08 TC FADE SET
1:TC FADE
0=OFF
1=ON
[ 0-1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
18
Toner save mode setting
Used to switch ON/OFF of the toner save mode.
When this simulation is executed, the current set value is displayed. Enter a set value with numeric keys and
press [OK] key or [START] key. The set value is saved in the EEPROM.
*
When this setting is changed, the toner save setting of the system settings is also changed accordingly.
Sim26-18 TONER SAVE
1:TONER SV MODE
0=OFF
1=ON
[ 0-1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
Code
:Setting
0=JAPAN
: Japan AB series
0
1=INCH
: Inch series
2=AB
: Ex Japan AB series
3=INCH(FC)
: Ex Japan inch series (FC)
0
4=AB(FC)
: Ex Japan AB series (FC)
5=CHINESE
: China (EX Japan AB series + Chinese paper support)
6=TAIPEI
: Taiwan (EX Japan AB series + Chinese paper support)
(Setting range 0 - 6)
(When setting is changed, the machine does not shift to the code input window.)
table setting)
Displayed CPM list
18CPM
20CPM
23CPM
Code: Setting
0: Manual transfer shaking countermeasures OFF
0
1: Manual transfer shaking countermeasures ON
0
Code: Setting
0: Toner save OFF
0
1: Toner save ON
0
MX-M182 SIMULATIONS 7-21
Contents
Remark
Default:
Differs depending
on each destination.
Default:
0
Advertisement
