Advertisement
Main
Sub
code
code
02
01
Single Paper Feeder(SPF)/Reversing single pass feeder(RSPF)aging
Used to check the operations of the SPF/RSPF unit and its control circuit.
Enter the magnification ratio and press[OK] key or [START] key to drive the SPF/RSPF unit at the speed
corresponding to the setting.
(Magnification ratio selection window)
Sim2-1 SPF AGING
115%
100%
86%
ZOOM
(Execution
window)
Sim2-1 SPF AGING
115%
100%
86%
ZOOM
*
When [INTERRUPT] key is press, the simulation is terminated and the machine returns to the sub code
input window.
*
When [CA] key is pressed, the simulation is terminated and the machine exits the simulation mode.
02
SPF/RSPF sensor status display
Used to display the sensor status in the SPF/RSPF section. An active sensor is highlighted.
Sim2-2 SENSOR CHECK
SPFP
L1
OCCV
L2
POUT
W0
SPFC
W1
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Returns to the sub code input window.
03
SPF/RSPF motor operation check
Used to check the operation of the SPF/RSPF motor and its control circuit. When this simulation is
executed, the initial menu shown below is displayed. Select the magnification ratio to drive the motor.
(Initial window = Magnification ratio selection window)
Sim2-3 OUTPUT CHECK
115%
100%
86%
ZOOM
(Execution
window)
Sim2-3 OUTPUT CHECK
115%
100%
86%
ZOOM
[CA] key: The SPF/RSPF motor is stopped, and the machine exits the simulation mode.
[INTERRUPT] key: The SPF/RSPF motor is stopped, and the machine returns to the sub code input window.
Select the scan magnification ratio (drive speed).
This also accords with the magnification ratio and
1SIDE
the speed in copying similarly to the OC.
2SIDE
The setting range is 50% - 200%.
100%
EXEC
[OK] key or [START] Key
1SIDE
"EXEC" is highlighted during execution.
2SIDE
100%
EXEC
Displayed name
SPFP
:SPF document transportation sensor
W2
OCCV
:SPF unit (OC cover) open/close sensor
W3
POUT
:SPF paper exit sensor
SPFC
:SPF paper feed cover open/close sensor
L1
:SPF paper length sensor 1
L2
:SPF paper length sensor 2
W0
:SPF document set sensor
W1
:SPF paper width sensor (small)
W2
:SPF paper width sensor (middle)
W3
:SPF paper width sensor (large)
Select the scan magnification ratio (drive speed).
This also accords with the magnification ratio and
the speed in copying.
The setting range is 50% - 200%.
100%
EXEC
[OK] key or [START] Key
"EXEC" is highlighted during execution.
100%
EXEC
MX-M182 SIMULATIONS 7-4
Contents
: Sensor name
Remark
Only when the SPF/
RSPF is installed.
Only when the SPF/
RSPF is installed.
Advertisement
