Advertisement
Main
Sub
code
code
02
08
SPF/RSPF paper feed solenoid operation check
Used to drive the SPF/RSPF paper feed solenoid (PSOL) 20 times in the cycle of 500msec of "ON" and
500msec of "OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-8 SPUS CHECK
PRESS OK KEY EXEC
When [INTERRUPT] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
09
RSPF reverse solenoid operation check
Used to drive the RSPF reverse solenoid (RSOL) 20 times in the cycle of 500msec of "ON" and 500msec of
"OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-9 SPFS CHECK
PRESS OK KEY EXEC
When [INTERRUPT] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
11
SPF/RSPF PS release solenoid operation check
Used to drive the SPF/RSPF PS release solenoid (CLH) 20 times in the cycle of 500msec of "ON" and
500msec of "OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-11 CLH CHECK
PRESS OK KEY EXEC
When [INTERRUPT] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
03
02
Shifter/job separator sensor status display
Used to monitor the sensors related to the shifter and the job separator and display the sensor status on the
LCD. An active sensor is highlighted.
Sim3-2 SENSOR
SFTHP
JSUP
TRYF
TRYD
*
Displayed only when the job separator is installed except for SFTH.
[OK] key or [START] Key
[OK] key or [START] Key
[OK] key or [START] Key
Displayed name :Sensor name
SFTHP
:Shifter home position sensor
JSDL
JSUP
:Job separator upper limit sensor
JSDL
:Job separator lower limit sensor
TRYF
:Tray full sensor
TRYD
: Paper exit sensor
MX-M182 SIMULATIONS 7-5
Contents
(Execution window)
Sim2-8 SPUS CHECK
EXEC
(Execution window)
Sim2-9 SPFS CHECK
EXEC
(Execution window)
Sim2-11 CLH CHECK
EXEC
Remark
(Only when the
SPF/RSPF is
installed.}
(Only when the
RSPF is installed.)
(Only when the
SPF/RSPF is
installed.)
(Sensor of shifter is
Japan only)
(Only when the job
separator is
installed.)
Advertisement
