Advertisement
3
WORK
3.7
Checking throttle cable routing
Warning
Danger of accidents The throttle cable may slip out of the guide if routed incorrectly.
The throttle slide will then no longer be closed and the speed can no longer be controlled.
–
Make sure that the throttle cable routing and the play in throttle cable complies with the specification.
3.8
Installing the shock absorber
Finishing work
–
Mount the seat. (
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank. (
Main work
–
Check throttle cable routing.
The throttle cable must be routed behind the handlebar, on the right of the
frame, and to the carburetor. The throttle cable must be secured behind the fuel
tank contact area rubber band.
»
If the throttle cable routing is not as specified:
–
Correct throttle cable routing.
E00336-01
Finishing work
–
Install the fuel tank. (
–
Mount the seat. (
Main work
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
V00344-11
Screw, bottom shock
absorber
Info
The heim joint for the shock absorber at the swingarm is Teflon-coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
Finishing work
–
Remove the motorcycle from the lift stand. (
p. 16)
p. 16)
p. 17)
p. 18)
p. 16)
to the side and position the shock absorber. Mount and
.
M12
.
M12
80 Nm
Loctite
®
2701™
(59 lbf ft)
Loctite
2701™
80 Nm
®
(59 lbf ft)
p. 16)
19
Advertisement
