Advertisement
3
WORK
3.11
Removing the battery (All 250/300 models, XC‑W US, XC‑W Six Days US)
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the front wheel bearing.
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
The brake linings are correctly positioned.
H00935-10
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake linings are seated cor-
rectly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times firmly.
V00364-11
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
(XC‑W US, XC‑W Six Days US, All 250/300 EU/AU/US models)
F00138-10
–
Disconnect negative cable
and contact surface
p. 33)
.
.
p. 16)
Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when
charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below
the minimum voltage.
Minimum voltage before the start
of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
from the battery.
of the spacers.
M20x1.5
35 Nm
(25.8 lbf ft)
p. 16)
M8
15 Nm
(11.1 lbf ft)
1 m (3 ft)
9 V
21
Advertisement
