KTM 125 XC-W EU 2017 Setup Instructions page 7

2 SETUP
(All Six Days models)
–
Remove screws
–
Move the handlebar supports to the desired position and mount and tighten
screws
Guideline
Screw, handlebar support M10
S01415-10
–
Position the handlebar.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp
S01413-01
(125 XC‑W EU)
–
Position the controls on the right half of the handlebar.
S01450-01
(All XC‑W/XC‑W Six Days models, EXC EU, EXC Six Days EU, 300 EXC BR)
–
Position the controls on the right half of the handlebar.
S01451-01
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
 and take off handlebar supports.

.
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
40 Nm Loctite ®
(29.5 lbf ft)
M8 20 Nm
(14.8 lbf ft)
5
243™