2
SETUP
–
Disconnect plug-in connector
–
Connect turn signal cable harness plug-in connector to the main wiring harness
plug-in connector.
S01466-10
–
Remove screw
–
Remove screw
–
Remove screw
E00489-11
–
Remove screws
–
Carefully pull the tail light cable out of the frame, paying attention to the plug
as you do so.
–
Take off license plate holder with tail light toward the rear.
S01416-11
–
Remove screws
–
Drill a hole at the marking
E00491-11
on main wiring harness and take off.
with the collar bushing.
.
with negative cable and contact disk.
.
and hang the tail light to the side.
to the size of the marking.
10