2
SETUP
–
Connect the tail light plug-in connector to the main wiring harness plug-in con-
nector.
S01467-01
–
Position the CDI unit, and mount and tighten screws
–
Position the turn signal cable harness and main wiring harness and secure with
cable ties.
S01462-10
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screws
Guideline
Remaining screws, chassis
S01465-10
–
Attach the side cover in area
–
Mount and tighten screw
Guideline
Screw, subframe
–
Mount and tighten screw
Guideline
Remaining screws, chassis
S01464-10
–
Install the battery. (
–
Install the fuel tank. (
–
Position turn signal on both sides, mount nuts with washers and tighten.
–
Position license plate lamp on the license plate holder, and mount and tighten
screws
–
Mount reflector
–
Pass cable through the license plate holder.
E00496-11
–
Position license plate holder on the license plate holder.
–
Connect the plug-in connector of the license plate lamp.
–
Connect the plug-in connector of the left turn signal which is marked red.
–
Connect the plug-in connector of the right turn signal which is marked green.
–
Mount and tighten screws
E00497-11
Info
The wiring harness runs under the CDI unit.
with the washers.
and engage it in area
.
M8
.
p. 23)
p. 18)
.
on license plate holder .
.
with the washers.
.
M6
10 Nm
(7.4 lbf ft)
.
35 Nm
Loctite
®
(25.8 lbf ft)
M6
10 Nm
(7.4 lbf ft)
12
2701™