2
SETUP
–
Route the turn signal cable harness toward the rear and pass through the frame
paying attention to the plugs as you do so.
–
Route turn signal cable harness on the license plate holder and pass turn signal
cable harness through the drill hole.
–
Position tail light on license plate holder, and mount and tighten screws
E00492-11
–
Carefully pass the tail light cable through the frame, paying attention to the
plug as you do so.
–
Position license plate holder on the rear.
–
Mount and tighten screws
E00495-11
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Mount and tighten screw
Guideline
Remaining screws, chassis
E00489-11
.
with the collar bushing.
M6
.
M6
with negative cable and contact disk.
M6
11
.
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)