2
SETUP
–
Position turn signal on the headlight mask on both sides, mount nuts with
washers and tighten.
–
Connect the plug-in connector
brown cable colors of the turn signal cable harness.
–
Connect the plug-in connector
brown cable colors of the turn signal cable harness.
S01460-10
–
Connect plug-in connector
–
Connect plug-in connector
–
Secure turn signal relay
–
Install the headlight mask with the headlight. (
–
Remove the cable tie(s).
–
Remove screws
S01462-10
–
Route the turn signal cable harness from the front to the back as far as the bat-
tery compartment.
–
Position and secure turn signal cable harness using cable ties to the main
wiring harness under the rubber bands of fuel tank support.
S01463-01
–
Remove screw
–
Remove screw
–
Pull off the side cover in area
S01464-10
–
Remove screws
–
Pull off the main silencer from the manifold at rubber sleeve
S01465-10
Info
Pay attention to where the brake line is routed when doing so.
of the headlight.
of the turn signal switch.
with a cable tie and plug in the connector.
with washers and hang the CDI unit to the side.
.
.
and area
with the washers.
of the left turn signal using the violet and
of the right turn signal using the black and
p. 25)
and remove it toward the rear.
9
.