Parameter
Description
Permitted Values
Default
Parameter
Description
Permitted Values
Default
[1]
If you change this parameter, the device will reboot to make the change take effect.
[2]
X is the Wi-Fi ID. X=1-5.
Internet Port and PC Port
Yealink Teams devices support two Ethernet ports: Internet port and PC port. You can enable or disable
the PC port on the devices.
The PC port is not applicable to CP960 devices.
•
Supported Transmission Methods
•
Internet Port and PC Port Configuration
Supported Transmission Methods
Three optional methods of transmission configuration for the device Internet port and PC port:
•
Auto Negotiation
•
Half-duplex (transmit in 10Mbps or 100Mbps)
•
Full-duplex (transmit in 10Mbps, 100Mbps or 1000Mbps (not applicable to CP960))
Auto negotiation is configured for both Internet and PC ports on the device by default.
Internet Port and PC Port Configuration
The following table lists the parameters you can use to configure the Internet port and PC port.
Parameter
Description
Permitted Values
Default
Supported Devices All devices except CP960
static.wifi.X.eap_user_name
It configures the EAP authentication username of a specific wireless network.
Note: It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to
1 (Enabled).
String within 64 characters
Blank
static.wifi.X.eap_password
It configures the EAP authentication password of a specific wireless network.
Note: It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to
1 (Enabled).
String within 64 characters
Blank
static.network.pc_port.enable
It enables or disables the PC port.
0-Disabled
1-Auto Negotiation
1
[2]
<y0000000000xx>.cfg
[2]
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
| Device Network | 27