Triggering - The Trigger Subsystem; Trigger; Trigger[N]:Input - Keysight N777 C Series Programming Manual

4 Measurement Operations & Settings

Triggering - The TRIGger Subsystem

Command:

:TRIGger

Syntax: :TRIGger<wsp>NODEA|1|NODEB|2
Description: Generates a hardware trigger.
Parameters: 1 or NODEA:
2 or NODEB:
A hardware trigger cannot be effective in the DISabled triggering mode but can be effective in DEFault, PASSthrough or
LOOPback triggering modes, see
:TRIGger
Response: None
Example: :trig 1
Command:

:TRIGger[n]:INPut

Syntax: :TRIGger[n]:INPut<wsp><trigger response>
Description: Sets the incoming trigger response and arms the module.
Parameters: IGNore:
NEXTstep:
SWStart:
Response: None
Example: :trig0:inp ign
Affects: All tunable laser modules
86
The TRIGger Subsystem allows you to configure how the instrument reacts
to incoming or outgoing triggers.
Is identical to a trigger at the Input Trigger Connector.
Generates trigger at the Output Trigger Connector.
:TRIGger:CONFiguration
on page 86 describes the :TRIGger command for advanced users.
Ignore incoming trigger.
Perform next step of a stepped sweep.
Start a sweep cycle.
on page 88 for information on triggering modes.
Keysight N777xC Series Tunable Laser Family Programming Guide