Command Summary - Keysight N777 C Series Programming Manual

2

Command Summary

Command Summary
20
The commands are ordered in a command tree. Every command belongs
to a node in this tree.
The root nodes are also called the subsystems. A subsystem contains all
commands belonging to a specific topic. In a subsystem there may be
further subnodes.
Table 4 on page 20 gives an overview of the command tree. You see the
nodes, the subnodes, and the included commands.
Table 4 Command Summary
Command
CONFigure Subsystem
:CONFigure:MEASurement:SETTing:ACTual?
:CONFigure:MEASurement:SETTing:NUMBer?
:CONFigure:MEASurement:SETTing:PRESet
:CONFigure:MEASurement:SETTing:CANCel
:CONFigure:MEASurement:SETTing:RECall
:CONFigure:MEASurement:SETTing:SAVE
:CONFigure:MEASurement:SETTing:ERASe
Command
SOURce Subsystem
:SOURce0:AM:COHCtrl:COHLevel?
:SOURce0:AM:COHCtrl:COHLevel
:SOURce0:AM:SOURce?
:SOURce0:AM:SOURce
:SOURce0:AM:STATe
:SOURce0:AM:STATe?
Keysight N777xC Series Tunable Laser Family Programming Guide
Page
Page 83
Page 83
Page 83
Page 84
Page 84
Page 84
Page 85
Page
Page 63
Page 63
Page 64
Page 64
Page 64
Page 65