Table of Contents
Advertisement
4-Port Installation
4-Port Installation
Caution
Caution
16 - DeviceMaster UP User Guide: 2000451 Rev. C
Use the following procedure to install the DeviceMaster UP 4-port.
1. Record the MAC address, model number, and serial number of the
DeviceMaster UP unit on the customer service label provided.
You may need the MAC address during driver configuration. The serial
number and MAC address are located on a label on the device. The MAC
address starts with 00 C0 4E.
2. Optionally, attach the mounting brackets using the screws provided in the kit
(6-32 1/4" flathead machine) or place the DeviceMaster UP on a stable surface.
Failure to use the correct screws can damage the PCB and void the
warranty. Do NOT use screws that exceed the length of the screws
provided with the mounting bracket kit.
Note: If you ordered the DeviceMaster Rackmount Shelf Kit accessory, use the
document that accompanied that kit or
mount the DeviceMaster UP on the shelf.
3. Connect the DeviceMaster UP to the same Ethernet network segment as the
PLC using one of the following methods:
•
Ethernet hub or switch (10/100Base-T): Connect to the port labeled UP
on the DeviceMaster UP using a standard Ethernet cable.
•
Server NIC (10/100Base-T): Connect to the port labeled DOWN on the
DeviceMaster UP using a standard Ethernet cable.
•
Daisy-chaining DeviceMaster UP units: Connect the port labeled
DOWN on the first DeviceMaster UP to the port labeled UP on the second
DeviceMaster UP or other device using a standard Ethernet cable. Refer to
Daisy-Chaining DeviceMaster UP 4-Port Units
information.
Note: Do not connect multiple units until you have changed the default IP
address, see
The default serial port setting for the DeviceMaster UP is RS-232. Do
not connect any serial devices until you have configured the serial port
settings. You must first configure the network settings and upload the
firmware on the DeviceMaster UP before configuring the serial port
settings.
4. Apply power to the DeviceMaster UP by connecting the AC power adapter to
the DeviceMaster UP, the appropriate power cord for your location to the
power adapter, and plugging the power cord into a power source. If you want
to provide your own power supply, see
Larger Picture,
Configuring the DeviceMaster UP
Power Supply for the 4-Port
Page 36
download the document
on Page 51 for more detailed
on Page 19.
on Page 32.
Hardware Installation
to
Advertisement
Table of Contents
Troubleshooting
