Establishing A Telnet Connection - Comtrol DeviceMaster Up Hardware Installation Manual

Establishing a Telnet Connection

Establishing a
Telnet Connection
40 - DeviceMaster UP User Guide: 2000451 Rev. C
7. Go to the appropriate task:
• Determining the Network Settings
• Configuring the Network Settings
• Determining the Bootloader Version
• Resetting the DeviceMaster UP
• Uploading Firmware
• Configuring Passwords
• Redboot Command Overview
Use the following procedure to telnet to the DeviceMaster UP.
Note: If you are not familiar with telnet, this procedure may be difficult to use.
1. Open a telnet session, enter the DeviceMaster UP IP address.
Note: Press the Enter key if you have not programmed a password or use the
password previously configured. The DeviceMaster UP does not come
preprogrammed with a password.
2. Type reset, and close the session.
3. Open a new telnet session, enter the DeviceMaster UP IP address, and the
password.
4. Type dis to disable the bootloader.
$ telnet 192.168.250.250
Trying 192.168.250.250...
Connected to 192.168.250.250.
Escape character is '^]'.
Password:
Comtrol DeviceMaster Boot Version 1.20
RedBoot(tm) debug environment - built 14:57:53 Jun 21 2004
Platform: Comtrol DeviceMaster (ARM 7TDMI)
Portions Copyright (C) 2000. Red Hat, Inc.
Portions Copyright (C) 2001-2004. Comtrol Corp.
RedBoot>dis
Loading disabled
5. Verify that the system responds with a Loading disabled message.
6. Go to the appropriate task:
• Determining the Network Settings
• Configuring the Network Settings
• Determining the Bootloader Version
• Resetting the DeviceMaster UP
• Uploading Firmware
• Configuring Passwords
• Redboot Command Overview
on Page 41
on Page 41
on Page 42
on Page 42
on Page 43
on Page 46
on Page 47.
Default IP Address
on Page 41
on Page 41
on Page 42
on Page 42
on Page 43
on Page 46
on Page 47.
RedBoot Procedures