Table of Contents
Advertisement
Protocols Supported
Quick Start
Getting Started
Getting Started
This guide discusses initial DeviceMaster UP installation, configuration, and
provides information on locating DeviceMaster UP protocol-specific software and
related installation documentation.
The DeviceMaster UP is a network attached, solid-state 1 or 4-port device server,
which hosts an Industrial Ethernet® engine and translates device
communications to a programmable logic controller (PLC) and any serial device.
After installing the appropriate firmware for your DeviceMaster UP, it enables
connectivity between any PLC® and any serial device. The DeviceMaster UP
supports the following protocols:
•
EtherNet/IP
•
Modbus/TCP
•
PROFINET CbA
Note: This guide does not discuss configuring the port characteristics or protocol-
specific programming information. See
Documentation
on Page 6 to locate the firmware and the appropriate
documentation for your environment.
Installation and configuration follows these steps.
1. Install the hardware
2. Install PortVision Plus
3. Configure the DeviceMaster UP network settings
4. Update the firmware on the DeviceMaster UP for your protocol
5. See
Locating Software and Documentation
installation document for your protocol so that you can perform the following
procedures:
a. Configure port characteristics using the Server Configuration web page.
b. Program the PLCs.
6. Connect the serial device or devices
Locating Software and
(Page
9).
(Page
19).
on Page 6 to locate the appropriate
(Page
25).
DeviceMaster UP User Guide: 2000451 Rev. C - 5
(Page
20).
(Page
22).
Advertisement
Table of Contents
Troubleshooting
