Comtrol DeviceMaster Up Hardware Installation Manual page 23

Configuring the DeviceMaster UP
5. Select Yes to upload the firmware.
6. Select OK to the advisory message about waiting until the DeviceMaster UP is
on-line and in the next minute the DeviceMaster UP unit or units should
display ON-LINE in the Status field
7. Go to the appropriate
information about configuring the serial port or ports and programming your
PLCs.
8. After configuring the serial port characteristics and preparing your PLC
programs, you can use the next section in this guide, to attach the serial device
or devices.
Uploading Protocol-Specific Firmware on the DeviceMaster UP
DeviceMaster UP User Guide
DeviceMaster UP User Guide: 2000451 Rev. C - 23
for your protocol for