Mounting The Embedded 1-Port - Comtrol DeviceMaster Up Hardware Installation Manual

Mounting the
Embedded 1-Port
Caution
Caution
Hardware Installation
Use the following procedure to mount the DeviceMaster UP 1-Port Embedded
with the 5-30VDC power supply.
Observe proper ESD techniques when handling the DeviceMaster UP.
1. Carefully remove the DeviceMaster UP from the anti-static bag, following
standard electrostatic device handling procedures.
Note: Write down the MAC address located on a label on the bottom (solder
side) center of the DeviceMaster UP because you may need it during
configuration.
2. Mount the DeviceMaster UP for your environment using 1/4" stand-offs to
separate the DeviceMaster UP from the base.
5-30VDC Model
1
Non-plated/non-grounded mounting holes 0.116" diameter (+/-0.003").
2
Plated/chassis grounded mounting hole 0.116" diameter (+/-0.003").
3
WARNING: Holes in hatched area are not mounting holes.
4 Maximum component height above board is 0.55".
5
Ethernet connection J1: J1 overhangs board edge by 0.14" and the height is 0.55".
6 Power connector; the mating connector is Weidmuller P/N: 152651.
7 LED light pipe mounting holes. The LED light pipes are not provided.
Serial port connector J2: 0.1" pin spacing, 0.025" square pin diameter, and 0.230"
8
pin height.
9 Debug port connector J3: 0.1" pin spacing, 0.025" square pin diameter, and 0.230"
pin height.
3. Use one of the following methods to ground the DeviceMaster UP.
• Through the power supply by connecting the ground wire on the power
cable using plastic or metal stand-offs.
• Through the chassis, using metal stand-offs. If plastic stand-offs are used
to mount the board, then you must ground the DeviceMaster UP using the
power cable.
Note: The maximum diameter of the metal stand-offs should be 0.175" with a
4-40 machine screw. Metal stand-offs are not provided with the
DeviceMaster UP.

Mounting the Embedded 1-Port

DeviceMaster UP User Guide: 2000451 Rev. C - 13