Comtrol DeviceMaster Up Hardware Installation Manual page 21

Hide thumbs Also See for DeviceMaster Up:

Table of Contents

Configuring the DeviceMaster UP

7. Change the device network properties as required for your site.

Select one of the following options:

Select this option if you want to run the device

using the MAC addressing scheme.

Disable IP

EtherNet/IP Users: The DeviceMaster UP does not

support Disable IP.

Select this option if you want to use the device with

DHCP. Make sure that you provide the MAC

DHCP IP†

address of the device to the network administrator.

Select this option to program a static IP address

and type the appropriate IP address, subnet mask,

Static IP†

and default gateway values for your site in the

provided boxes.

† PROFINET Users:

The network address entered here must match the IP address

entered in SIMATIC

PROFINET User Guide

addresses.

8. Select Apply Changes and Close. It may take up to a minute for the

DeviceMaster UP status return to ON-LINE.

9. If you have not done so, upload the appropriate protocol firmware for your

environment using the next subsection,

on the DeviceMaster UP

Configuring the DeviceMaster UP Network Settings

iMap. See the

DeviceMaster UP

for information about assigning

Uploading Protocol-Specific Firmware

on Page 22.

DeviceMaster UP User Guide: 2000451 Rev. C - 21

Table of Contents

Troubleshooting