Determining The Network Settings; Configuring The Network Settings - Comtrol DeviceMaster Up Hardware Installation Manual

Determining the Network Settings

Default Network Settings
IP address:
192.168.250.250
Subnet mask:
255.255.0.0
Gateway address:
192.168.250.1

Configuring the Network Settings

RedBoot Procedures
If you are not sure what the network information is on a DeviceMaster UP, you
can perform the following procedure.
1. Establish communications with the DeviceMaster UP using the serial (Page
39) or telnet (Page 40) method.
2. At the RedBoot prompt, type ip.
RedBoot>dis
Loading disabled
RedBoot> ip
IP Config: IpAddr 192.168.250.250 IpMask 255.255.0.0 IpGate 192.168.250.1
RedBoot>
The IP address, subnet mask, and IP gateway values will display.
The following subsections show you how to establish a communications link with
Redboot on the DeviceMaster UP, by using one of these methods:
• Serial connection between Port 1 on the DeviceMaster UP and a COM port on
a PC.
If you do not know the IP address of the DeviceMaster UP you must use a
serial connection to communicate with the DeviceMaster UP.
• Telnet connection requires that you know the IP address. In addition, the IP
address must also be valid for the network to which it is attached. For
example: The network segment must be 192.168.250.x to telnet to the
DeviceMaster UP default IP.
Use the following procedure to program the IP address using Redboot.
1. Establish communications with the DeviceMaster UP using the serial (Page
39) or telnet (Page 40) method.
2. Enter ip [addr mask gateway] and press the Enter key to configure the IP
address.
Where:
addr = IP address you want to use
mask = matches you network subnet mask
gateway = assigned by your network administrator
Make sure that each value is separated by a space.
RedBoot>dis
Loading disabled
RedBoot> ip
###.###.###.### ###.###.###.### ###.###.###.###
RedBoot> ip
IP Config: IpAddr
###.###.###.###
RedBoot> reset
... Resetting
3. Verify that Redboot responds with your configured network information or
reissue the command.
4. Type reset to reset the DeviceMaster UP, if you do not have any other related
Redboot tasks.
Determining the Network Settings
IpMask IpGate
###.###.###.###
DeviceMaster UP User Guide: 2000451 Rev. C - 41
###.###.###.###