1-Port Embedded Installation; Building The Serial Ribbon Cable - Comtrol DeviceMaster Up Hardware Installation Manual

1-Port Embedded Installation

1-Port Embedded Installation
Building the Serial
Ribbon Cable
12 - DeviceMaster UP User Guide: 2000451 Rev. C
Installing the DeviceMaster UP 1-Port Embedded system follows these basic
steps:
• Building the serial ribbon cable (below).
• Mounting the Embedded 1-Port
• Attaching the Network and Serial Cables
• Connecting the Power and Verifying Installation
Use the following information to build a DB9 serial ribbon cable to connect to the
DeviceMaster UP 1-Port Embedded IDC10 connector (J2).
10-Pin
Socket
J2 Header
on Page 13 and installing light pipes.
on Page 14.
9 10
Ribbon Cable
1 2
J2
RS-232 RS-422
1 CD Not used Not used
2 DSR Not used Not used
3 RxD RxD-
4 RTS TxD+
5 TxD TxD-
6 CTS RxD+
7 DTR Not used Not used
8 RI Not used Not used
9 GND Not used Not used
10 Not connected
on Page 14.
Pin 5 Pin 9
DB9
Male
Pin 6
Pin 1
RS-485
Not used
TRX+
TRX-
Not used
Hardware Installation