Configuring The Devicemaster Up Network Settings - Comtrol DeviceMaster Up Hardware Installation Manual

Hide thumbs Also See for DeviceMaster Up:

Table of Contents

Configuring the DeviceMaster UP Network Settings

Default Network Settings

IP address:

192.168.250.250

Subnet mask:

255.255.0.0

Gateway address:

192.168.250.1

20 - DeviceMaster UP User Guide: 2000451 Rev. C

Use the following procedure to change the DeviceMaster UP network settings.

Note: The DeviceMaster UP must be connected to the same local network segment

as the computer on which PortVision Plus is installed.

1. If you have not done so, install PortVision Plus (see

PortVision Plus

on Page 19).

2. If necessary, start PortVision Plus by double-clicking the PortVision Plus icon

or select Start > Programs > Comtrol > PortVision Plus.

3. If this is the first time PortVision Plus has been opened, select the Scan button

to locate DeviceMaster UP units on the network.

4. Highlight the DeviceMaster UP for which you want to program network

information and select the Config button.

Optionally, you can double-click on the DeviceMaster UP or right-click on the

DeviceMaster UP and select Configure Device.

Note: The Status column for the DeviceMaster UP must display ON-LINE

before you can go to the next step.

5. Optionally, rename the device in the Device Name box.

6. If necessary, select This device is on the local network.

Installing and Upgrading

Configuring the DeviceMaster UP

Table of Contents