Mounting The Embedded - Comtrol DeviceMaster PRO Installation And Configuration Manual

Mounting the
Embedded
Caution
Caution
DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
Use the following procedure to mount the DeviceMaster 1-Port Embedded with the 5-
30VDC power supply.
Observe proper ESD techniques when handling the DeviceMaster.
1. Carefully remove the DeviceMaster from the anti-static bag, following standard
electrostatic device handling procedures.
Note: Write down the MAC address located on a label on the bottom (solder side)
center of the DeviceMaster because you may need it during configuration.
2. Mount the DeviceMaster for your environment using 1/4" stand-offs to separate the
DeviceMaster from the base.
5-30VDC Model
1
Non-plated/non-grounded mounting holes 0.116" diameter (+/-0.003").
2
Plated/chassis grounded mounting hole 0.116" diameter (+/-0.003").
3
WARNING: Holes in hatched area are not mounting holes.
4 Maximum component height above board is 0.55".
5
Ethernet connection J2: J2 overhangs board edge by 0.14" and the height is 0.55".
6 Power connector; the mating connector is Weidmuller P/N: 152651.
7
LED light pipe mounting holes. The LED light pipes are not provided.
Serial port connector J3: 0.1" pin spacing, 0.025" square pin diameter, and 0.230"
8
pin height.
9 Debug port connector J4: 0.1" pin spacing, 0.025" square pin diameter, and 0.230"
pin height.
3. Use one of the following methods to ground the DeviceMaster.
• Through the power supply by connecting the ground wire on the power cable
using plastic or metal stand-offs.
• Through the chassis, using metal stand-offs. If plastic stand-offs are used to
mount the board, then you must ground the DeviceMaster using the power cable.
Note: The maximum diameter of the metal stand-offs should be 0.175" with a 4-40
machine screw. Metal stand-offs are not provided with the DeviceMaster.
4. Optionally, attach the light pipes. The following light pipes have been tested and found
to function; Bivar, Inc. (P/N:LP-230) and Ledtronics, Inc.
(P/N:LTP003-0CW-001).

Mounting the Embedded

Hardware Installation - 17