Lifetime PUMP ADJUST 90469 Assembly Instructions Manual page 5

SECTION 1 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
(1)
(1)
(1)
1.1
• Dig a round hole 24" deep and 21" in diameter. If
you live in an area where frost heaves may pose a
problem, consult your local building inspector to
determine the proper hole depth. The edge of the
hole should be fl ush with the edge of the playing
surface.
!
• A Ground Sleeve is available as an alternative to
cementing the Pole into the ground. Please contact
Customer Service for more information.
1.2
• Make a mark 16 inches from the dimpled
end of the Bottom Pole (ALE) (do not scratch
the powder coating). Slide the Alignment
Frame (BGW) over the Bottom Pole.
ALE
16"
640 lb / 291 kg
1.3
ALE
BGW
5
• Mix the concrete. Save 1/2 bag of concrete mix
to use later in the assembly. Pour the mixed
concrete into the hole until it is fi lled to the level
of the playing surface.