Lifetime PUMP ADJUST 90469 Assembly Instructions Manual page 38

SECTION 6 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
(1)
6.9
• Raise the Backboard until it would not go futher. Use a pencil to mark where the bottom of the Gas Spring Cover (AKG) meets
the Gas Spring (AJR). Squeeze the Gas Spring Cover and apply the Height Adjust Sticker (AKP) to the back of the Gas Spring,
lining up the 10' line with the pencil mark. Press the Sticker into place while slowly removing the rest of the backing.
!
• Actual Height Sticker (AKP) and Gas Spring Cover (AKG)
may vary from those shown here.
AKG
AJR
Squeeze
here
34
Squeeze
here
AKP