Lifetime PUMP ADJUST 90469 Assembly Instructions Manual page 12

SECTION 3 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
1/2" (13 mm)
(1)
3.1
• Insert two Carriage Bolts (EAP) through the Rim Pivot Bracket (APY) as shown.
3.2
• Use the 1/2" socket head from the socket head wrench to press one Push Nut (AAQ) onto one end of the Axle
(ABQ).
!
• The Push Nut should rest about 1/4" from the end of the
Axle. If the Push Nut slips on too far, continue sliding it to the
other end of the Axle to remove it and try again.
3.3
• Slide the end of the Axle (ABQ) through the Rim (ALX) and the Rim Pivot Bracket (APY). Press the Push Nut (AAQ) onto
the end of the Axle. Use the 1/2" socket head to secure the Push Nut if needed.
ALX
APY
ABQ (x1)
EAP
(x2)
EAP
APY
ABQ
(Not to scale)
EAP
AAQ
ALX
ABQ
12
AAQ (x2)
ABQ
AAQ