Lifetime PUMP ADJUST 90469 Assembly Instructions Manual page 14

SECTION 3 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
1/2" (13 mm)
(2)
3.5
• Thread two Jam Nuts (AAV) all the way on to the U-Bolt (APZ). Then slide the Compression Springs (AJW) onto the U-Bolt
and place the Spring Retainer Plate (AOW) over the Compression Springs. Tighten the Nylock Flange Nuts (ABK) until the
Rim (ALX) does not wobble to complete this step.
!
• DO NOT COMPLETELY TIGHTEN THE NYLOCK FLANGE NUTS IN
THIS STEP! Only tighten the nuts until the Rim does not wobble.
Tightening the Nuts will adjust the Rim tension.
3.6
• Attach the Rim Cover Plate (AMA) to the Rim with the hardware shown.
AAV (x2)
AAV
APZ
AJW (x2)
ABK (x2)
AMA
14
ADR (x4)
ABK
AOW
AJW
ADR
ADR
ADR
ADR