SECTION 5 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
7 1/16"
3/4" (19 mm)
AAD (x1)
ANZ (x2)
(2)
(1)
AAX (x1)
AOR (x2)
CKT (x1)
5.9
• Connect the Rear Lifter Arms (ALS) to the inside of the Long Extension Arms (AKB) with the hardware shown. Place a
Spacer (CKT) between the Rear Lifter Arms as shown, with a Spacer (ANZ) between the Rear Lifter Arms and the
Long Extension Arms on each side. Tighten the hardware in this step and in steps 4.3 securely now.
CKT
ANZ
ALS
AAD
ALS
ANZ
ANZ
AOR
CKT
!
• Tighten the Centerlock Nut (AAX) until it is
AOR
fl ush with the end of the Bolt.
AAX
27