Lifetime PUMP ADJUST 90469 Assembly Instructions Manual page 37

SECTION 6 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
(1)
(1)
(3)
6.7
• While two people continue to hold the assembly in place, set a block of Scrap Wood on top of the Rigid Arms
and strike it 5-6 times with a hammer or mallet. You must have wood on top of the Arms before hitting them with a
hammer to prevent scratching the powder coating. The bottom edge of the Middle Pole must reach within a half-inch
of the 5-inch mark on the Bottom Pole.
6.8
• After the Poles have been seated, measure up 1" from the bottom center of the Middle Pole (ALF) and insert one
Self-Tapping Screw (CMV) into the Pole as shown.
(1)
!
CMV (x1)
• If your Pole sections do not reach within 1/2" of the 5"
mark after seating, DO NOT COMPLETE ASSEMBLY. Call
our Customer Service number for assistance.
Use extreme caution when standing on ladders to
perform assembly steps.
Wood Block
The Poles must be seated together! Even if the Poles cover
the slots before seating, they must be struck on a hard
surface five to six times! Failure to seat the Poles correctly
could allow the Poles to separate during use, which could
lead to serious personal injuries or property damage.
ALH
33
WARNING
WARNING
CMV
1" up from bottom of
Top Pole