Installing A Module - Nortel 8600 Installation Manual

Installing a module

Install a module to replace an existing module or to add new capability to
your Ethernet Routing Switch 8600. Installing a module takes three to five
minutes.
Prerequisites
•
Copyright © 2008 Nortel Networks
.
Do not operate a chassis without either a filler panel or a module
installed in a slot.
If you insert a SAM into a chassis where another SAM resides, make
sure that the first module is fully initialized before you insert the
second.
CAUTION
Risk of equipment damage
Electrostatic discharge can damage hardware. Follow proper
ESD-elimination procedures.
Nortel Ethernet Routing Switch 8600
Installation — Modules
NN46205-304 02.02 Standard
16 June 2008
Installing a module 93
--End--