Nortel 8600 Installation Manual page 42

42 Ethernet Routing Switch 8600 module fundamentals
supports the IEEE 802.3 1998 Clause 28 Auto-Negotiation standard, the
two devices negotiate the highest possible data rate and the duplex mode
of operation.
For a list of Nortel-qualified GBICs, see
GBICs" (page
The following figure shows the location of the 8632TXE and 8632TXM
module LEDs.
Figure 15
8632TXE and 8632TXM module LEDs
The following table describes the 8632TXE and 8632TXM module LEDs.
Table 7
8632TXE and 8632TXM module LEDs
Type Label
Module Online
Port 10/100
Link/Act
Copyright © 2008 Nortel Networks
.
64).
Color, State
Green, Steady
Amber, Steady
Off
Green, Steady
Off
Green, Steady
Green, Blinking
Off
Nortel Ethernet Routing Switch 8600
Installation — Modules
NN46205-304 02.02 Standard
16 June 2008
"Nortel-qualified SFPs, XFPs, and
Meaning
The module completed the power-on
self-test and software initialization and is
operating normally.
The module failed the power-on self-test.
The module power is off. If the switch
power is on, the module is performing
its power-on self-test and software
initialization. A module in this state is not
yet functional.
The port is operating at 100 Mbps.
The port is operating at 10 Mbps.
The port is connected and the link is
operational.
Data is passing through the port.
The port is disabled or has no link.