Connecting A Network Management Station To The Sf/Cpu - Nortel 8600 Installation Manual

2
3

Connecting a network management station to the SF/CPU

Use the management port to connect the switch to a network management
station for out-of-band management using a Web browser or Device
Manager.
Procedure steps
Step
1
2
Copyright © 2008 Nortel Networks
.
Connecting a network management station to the SF/CPU 105
Setting
Synchronous/asynchronous
mode
Auto answer
Local character echo
Supervisory functions
Baud rate
Data bits
Stop bits
Parity
Insert the 9-pin receptacle end of the serial cable into the modem
connector on the 8691 SF/CPU or 8692 SF/CPU module.
Insert the 25-pin plug connector into the modem RS-232 data
communications port.
Action
Connect an Ethernet cable to the network management station.
For 10 Mbps connections, you can use Category 3, 4, or 5
copper unshielded twisted pair (Ethernet) cable. Use only
Category 5 UTP cable to connect ports that operate at 100
Mbps.
Connect the other end of the cable to the RJ-45 jack on the 8691
SF/CPU or 8692 SF/CPU module.
Nortel Ethernet Routing Switch 8600
Installation — Modules
NN46205-304 02.02 Standard
16 June 2008
Value
Asynchronous
Answer on two rings when DTR is
active.
Off
Off
9600
8
1
None
--End--
--End--