Replacing The Fuses - Toro Workman GTX Series Operator's Manual

Connecting the Batteries
1. Ensure that the battery terminals are clean and
free of oxidation.
2. Connect the main positive-battery cable (red)
between the bank of batteries and the machine
(Figure 38).
3. Connect the main negative-battery cable (black)
between the bank of batteries and the machine
(Figure 38).
4. Torque the nuts securing all of the battery cables
until the retainer securely grips the battery.
5. Coat the battery terminals with Toro
battery-terminal protector.
6. Ensure that the rubber boots on each battery
cable are securely seated over the battery
terminals.
7. Insert the key into the key switch and rotate the
switch to the O
N
8. Lower the cargo bed, rotate the key switch to
the O position, and remove the key.
FF
Storing the Batteries
Charge the batteries fully before placing the machine
into storage. Plug the charger into a wall outlet while
the machine and batteries are in storage. Leave
the charger plugged into a wall outlet and charging
receptacle during storage to ensure that the batteries
stay charged and do not freeze; otherwise, charge the
batteries at least once a month.
Important:
If the machine cannot be plugged
in during storage, fully charge the batteries at
least once a month. The batteries self-discharge
over long periods of time, which may damage the
batteries to the point of being unusable, even if
the batteries are new.
position.

Replacing the Fuses

There are 4 fuses in the electrical system; the other
slots are open for options. They are located under the
seat assembly behind a battery on the right side of
the machine (Figure
Main power
Electric relay
USB power point
Headlights
Optional lift kit—open
Horn—optional (standard on
international models only)
1. Fuse block
37
39).
Figure 39
10 A
20 A
5 A
10 A
15 A
30 A
g277605