Lifting The Machine; Accessing The Hood - Toro Workman GTX Operator's Manual

Lifting the Machine

DANGER
The machine may be unstable when using
a jack. The machine could slip off the jack,
injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is
supported by lifting equipment.
• Use jack stands to support the machine
once you have lifted it.
Important:
Whenever you run the machine for
routine maintenance and/or diagnostics, ensure
that the rear wheels of the machine are 25 mm (1
inch) off the ground, with the rear axle supported
on jack stands.
•
The lifting point at the front of the machine is
located at the front of the frame, behind the towing
tongue (Figure 23).
Figure 23
1. Front lifting point
•
The lifting point at the rear of the machine is
located under the axle tubes
g034043
(Figure 24).
29
Figure 24
1. Rear lifting points

Accessing the Hood

Raising the Hood
1. Lift up the handle of the rubber latches on each
side of the hood
Figure 25
2. Raise the hood.
Closing the Hood
1. Gently lower the hood.
2. Secure the hood by aligning the rubber latches
onto the latch anchors on each side of the hood
(Figure 25).
(Figure 25).
g034407
g034045