Turning The Power On/Off - Konica Minolta CA-410 Instruction Manual

Turning the Power ON/OFF

1. Turning the Power ON/OFF
Before setting the POWER switch to ON, complete the following. When turning the power ON for the first time after
purchase, the language selection and date/time setting screens appear. Set the display language and the date/time on
these screens.
Operating Procedure
1
Connect a probe to a probe connector. (P. 21)
• To synchronize measurement with the
display's vertical synchronization signal
(EXT is selected as the measurement
synchronization mode)
• To perform measurement simultaneously
with multiple probes
• To communicate with a PC via RS-232C
• To communicate with a PC via USB
• To communicate with a PC via Ethernet
2
Connect the power cord to an outlet.
(P. 61)
Turning the Power ON
Set the POWER switch to ON.
• When turning the power ON for the first time after
purchase, the language and internal clock setting
screens appear. Set the display language and the
date/time on these screens by referring to pages
116 and 118.
Turning the Power OFF ()
Set the instrument's POWER switch to OFF ().
Error Messages on the LCD Display: For other error messages, refer to page 134.
"Probe connection error"
• Cause: A probe was connected or disconnected
while the POWER switch was ON.
• Action: Set the POWER switch to OFF first,
connect necessary probes, then set the
POWER switch to ON. (Before
connecting/disconnecting a probe,
make sure that the POWER switch is set
to OFF.)
(1) Input the vertical synchronization signal that is used for the
display. (P. 22)
(1) Connect the necessary number of probes to the probe
connectors. (P. 21–23)
(1) Connect the instrument to the PC using an RS-232C cable.
(P. 122)
(2) On the menu selection screen, select the RS-232C baud rate.
(P. 123)
(1) Connect the instrument to the PC using a USB cable. (P. 124)
(1) Connect the instrument to the PC using a LAN cable. (P. 125)
(2) On the menu selection screen, set the IP address, subnet
mask, and default gateway. (P. 126)
63
Power switch
Power switch