Konica Minolta CA-410 Instruction Manual page 99

5
The screen for selecting a calibration
channel is displayed. Press the [UP] or
[DOWN] key to select the channel to
register. This screen allows the current
data to be checked.
6
Press the [ENTER] key.
The pop-up screen for target value measurement is
displayed with the "MEAS" button on it. Press the
[ENTER] key again to perform measurement.
7
When an appropriate target value is
obtained, press the [ENTER] key to hold
the value.
8
Press the [UP] or [DOWN] key and the
[RIGHT]/[LEFT] keys to select the field of
a target, and then press the [ENTER] key.
9
Press the [UP] or [DOWN] key and the
[RIGHT]/[LEFT] keys to set a target
value, and then press the [ENTER] key.
(Press the [ESC] key to cancel configuration of the
setting and restore the original value.)
10
Repeat steps 8 and 9 to set target values,
move to [Complete], and then press the
[ENTER] key to confirm your entry.
(If the entered value is out of the available setting
range, the screen returns to the value entry screen.
Enter another value.)
11
Press the [ESC] key.
The measurement screen is displayed on the LCD
screen. The specified values will be kept even if the
POWER switch is set to OFF ().
MENU
Target ＞ Select CH
01 CH00
CH01
CH02
CH03
CH04
CH05
CH06
CH07
CH08
CH09
MENU
Target ＞ Select CH
Target
Start measurement
01
CH00
CH01
CH02
CH03
CH04
Measured Value
CH05
CH06
Target Value
CH07
CH08
CH09
MENU
Target ＞ Select CH
Target
Stop measurement
01
CH00
CH01
CH02
CH03
CH04
Measured Value
CH05
CH06
Target Value
CH07
CH08
CH09
MENU
Target ＞ Select CH
Target
Edit Value
01
CH00
To confirm by pressing the ENTER button
CH01
CH02
CH03
CH04
Measured Value
CH05
CH06
Target Value
CH07
CH08
CH09
97
Lv x y
Meas
Lv x y
160.2 0.3132 0.3257
Stop
Lv x y
160.2 0.3132 0.3257
Complete