Konica Minolta CA-410 Instruction Manual page 58

Manual Structure
This section explains measuring methods.
From Calibration/Settings section
Measurement
Explains measuring methods, how to hold the measured values, how to read them, and how to
clear them.
This section explains communication with a PC via RS-232C, USB, Ethernet, or Bluetooth.
Connection to a PC via RS-232C
Explains how to connect an RS-232C cable and select the RS-232C baud rate to enable two-way
communication with a PC or other device via RS-232C.
Connection to a PC via USB
Explains how to connect a cable to enable communication with a PC via USB.
Connection to a PC via Ethernet
Explains how to connect a cable and set the DHCP to enable communication with a PC via
Ethernet.
Connection to a PC via Bluetooth
Explains how to connect and set the Bluetooth module to enable communication with a PC or
other device via Bluetooth.
Communicating with a PC
• Bidirectional communication is possible between the data processor and a PC using an RS-232C, USB,
Ethernet, or Bluetooth connection.
When multiple means of communication are set, the means of communication used for sending the first
command from the PC will be enabled, and commands from all other means will be ignored.
• If the USB cable will be connected and disconnected frequently, please try to use RS-232C for connection.
If any problem occurs, contact a Konica Minolta-authorized service facility.
56
P. 101
P. 122
P. 124
P. 125
P. 128