Toro Line Painter 1200 Service Manual page 79

Installation (Fig. 13)
1. Position paint control cable to machine.
2. Connect paint control cable to paint control lever on
machine handle:
A. Slide cable end onto paint control lever and se-
cure with hair pin.
B. Secure cable to handle assembly with jam nut.
C. Make sure that cable boot is positioned over end
of cable.
3. Connect paint control cable to paint shutoff valve
(Figs. 14):
A. Secure cable clevis to shutoff valve lever with cle-
vis pin and hair pin.
B. Position shutoff valve lever to shutoff valve and
secure with two (2) cotterless pins.
C. Position cable to chassis bracket.
D. Tighten cable jam nuts to allow slight cable free -
play. Verify that operator control lever has
E. Make sure that cable boot is positioned over end
of cable.
4. After cable installation, verify that operator paint con-
trol lever has from .050" to .100" (1.3 to 2.5 mm) freeplay.
Readjust cable if necessary.
5. Secure high tension lead to spark plug.
Line Painter 1200
1. Paint control cable
2. Paint shutoff valve lever
1. Pivot cotterless pin
Page 6 – 15
4
2
3
Figure 14
3. Paint shutoff valve
4. Cable boot
1
2
Figure 15
2. Spool cotterless pin
Chassis and Controls
1