Spray Pump - Toro Line Painter 1200 Service Manual

Spray Pump

RIGHT
FRONT
1. Tank support
2. Flange head screw (4 used)
3. Spray pump assembly
4. Flange nut (3 used)
5. Pulley
Removal (Fig. 30)
1. Drain paint tank (see Operator's Manual).
2. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
Paint System
14
13
12
11
10
9
6. Flat washer
7. Cap screw
8. Lock washer
9. Set screw
10. Square key
4
5
6
8
7
Figure 30
3. Remove spray pump drive belt (see Spray Pump
Drive Belt Removal in this section).
4. Loosen two (2) set screws and then remove cap
screw (item 7), lock washer (item 8) and flat washer
(item 6) that secure pulley to pump shaft. Slide pulley
from pump shaft. Locate and retrieve square key (item
10).
Page 5 – 28
1
2
3
11. Chassis
12. Cap screw (3 used)
13. Flush tank
14. Paint tank
Line Painter 1200