Castor Release Cable - Toro Line Painter 1200 Service Manual

Castor Release Cable

9
8
1. Castor release lever
2. Rubber bumper
3. Traction lever
Removal (Fig. 8)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. Disconnect castor release cable from castor release
lever on machine handle:
A. Loosen jam nut that secures cable to handle as-
sembly.
B. Remove hair pin that retains cable end to castor
release lever.
C. Slide cable end from castor release lever.
3. Disconnect castor release cable from castor release
detent under front of machine (Figs. 9 and 10):
A. Loosen jam nuts that secure cable to chassis
bracket.
Chassis and Controls
2
1
7
6
4. Cap screw
5. Flat washer
6. Flange bushing
3
4
5
6
Figure 8
B. Remove hair pin and clevis pin that secure cable
clevis to castor release lever.
C. Slide cable clevis from release lever.
4. Note routing of castor release cable. Remove cable
from machine.
Installation (Fig. 8)
1. Position castor release cable to machine.
2. Connect castor release cable to castor release lever
on machine handle:
A. Slide cable end onto castor release lever and se-
cure with hair pin.
B. Secure cable to handle assembly with jam nut.
C. Make sure that cable boot is positioned over end
of cable.
Page 6 – 10
7. Flange nut
8. Castor release cable
9. Hair pin
Line Painter 1200