Paint Control Cable - Toro Line Painter 1200 Service Manual

Paint Control Cable

1. Paint control lever
2. Bushing
3. Bushing
Removal (Fig. 13)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. Disconnect paint control cable from paint control
lever on machine handle:
A. Loosen jam nut that secures cable to handle as-
sembly.
B. Remove hair pin that retains cable end to paint
control lever.
C. Slide cable end from paint control lever.
Chassis and Controls
3
Figure 13
4. Flange nut
5. Hair pin
6. Paint control cable
3. Disconnect paint control cable from paint shutoff
valve (Fig. 14):
A. Loosen jam nuts that secure cable to chassis
bracket.
B. Remove two (2) pins that secure paint shutoff
valve lever to shutoff valve. Shift position of lever to
allow cable clevis removal.
C. Remove hair pin and clevis pin that secure cable
clevis to paint shutoff valve lever.
4. Note routing of paint control cable. Remove cable
from machine.
Page 6 – 14
8
9
1
2
7
6
7. Rubber bumper
8. Cap screw
9. Flat washer
3
4
5
Line Painter 1200