Engine - Toro Line Painter 1200 Service Manual

Hide thumbs Also See for Line Painter 1200:
Table of Contents

Advertisement

Engine

10
9
8
7
6
250 to 450 in–lb
(28 to 51 N–m)
1. Engine
2. Oil drain valve
3. O–ring
4. Drain extension
5. Screw (6 used)
6. Washer head screw (2 used)
7. Nut (2 used)
Removal (Fig. 5)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. If engine is to be disassembled, it may be easier to
drain oil from engine before removing engine from ma-
chine (see Operator's Manual).
3. Close fuel shut off valve. Disconnect fuel hose from
carburetor inlet.
Gasoline Engine
11
12
13
5
5
Figure 5
8. Frame
9. Fuel tank support
10. Washer head screw (2 used)
11. Fuel tank cap
12. Fuel tank
13. Fuel tank bracket
4. Remove fuel tank from machine (see Fuel Tank Re-
moval in this section).
5. If machine is equipped with a hour meter, remove
hour meter pickup wire from spark plug lead on engine.
Position pickup wire away from engine.
6. Disconnect stop switch wire from engine (Fig. 6).
Make sure that ground wire is removed from fuel tank
bracket (item 14).
Page 3 – 8
15
14
2
1
4
3
18
19
14. Hose clamp (4 used)
15. Fuel hose
16. Fuel shut off valve
17. Fuel hose
18. Engine pulley
19. Cap screw
14
16
14
17
14
3
20 to 30 ft–lb
(27 to 41 N–m)
RIGHT
FRONT
50 to 60 ft–lb
(68 to 81 N–m)
Loctite #242
Line Painter 1200

Advertisement

Table of Contents
loading

Table of Contents